VESA Mounting Bracket 75x75 mm
To mount the device, you can use a VESA mounting bracket.
Follow the instructions below and the instructions in the VESA mounting bracket installation manual.
Wall Mounting
Suitable Surfaces:
Drywall
Wood/chipboard
Other similar surfaces
Tools Needed:
Little crosstip screwdriver
Bubble level and length meter
Drill
Expansion anchors
Mounting Material:
Procedure
Unscrew the little screw at the top of the device and remove the back cover.
Using the back cover as a template, mark the appropriate height and location
of the top screw/anchor (the middle hole at the top of the back cover).
Drill the screw/anchor (depending on the surface type) into the marked location.
Then attach the back cover to the wall using the screw. Level the upper edge of the cover and mark the locations of the remaining two screws/anchors.
Attach the back cover using the remaining screws, click the device into the solid mounted cover and fasten it using the little screw at the top of the device.
Connect the Ethernet (PoE) network cable and power supply if necessary.
Glass Mounting
Suitable Surfaces
Glass
Metal
Tiles
Other suitable (varnished) surfaces
Tools Needed
Little crosstip screwdriver
Bubble level
Length meter
Knife (or scissors)
Mounting Material
Grease remover (rubbing alcohol, acetone)
Cover sticker (to cover the back of the device, 280 mm x 187 mm, curve radius 25mm)
3M Dual Lock 25 mm reclosable fastener
Procedure
Unscrew the little screw at the top of the device and remove the back cover.
Cut the 3M Dual Lock 25 mm tape into four 12-cm-long strips. Attach the velcro strips to each other to create 2 pcs and stick them to the back of the cover you removed in step 1 (see picture below).
Degrease the surface where you wish to mount the back cover. Make sure you are using a suitable grease remover, as using an inappropriate agent (such as washing-up liquid, petrol or solvent) may result in bond strength deterioration by up to 70%.
If you mount your device on glass and need to cover the back of the device,
attach the cover sticker to the glass wall.
The location should be marked in the same way as the location of the device (see step 5).
Using the back cover, mark the appropriate height and level position.
Attach the back cover to the wall at the marked location.
Push the velcro to make sure the adhesive tape sticks properly.Click the device into the back cover and fasten it using the little screw
at the top of the device.
Connect the Ethernet (PoE) network cable and power supply if necessary.